John Deere 700H Crawler Dozer — Disassemble

Hydrostatic System 15. Scribe a line between end cap and housing to aid in assembly. Remove screws (1 and 2) retaining end cap assembly to motor housing. Remove end cap (3), gasket (4) and alignment pins (5). IMPORTANT: Special attention should be given to the orientation of the segment (6) with end cap and housing, alignment pins (7), rollers (8) with synchronizing shaft (recess faces the center-line of the shaft) and synchronizing shaft (9) with cylinder block (10) and output shaft. 16. Remove hydrostatic motor parts (6—11) as shown.

1—Cap Screw (4 used) 2—Cap Screw (4 used) 3—End Cap 4—Gasket 5—Alignment Pin (2 used) 6—Segment 7—Alignment Pins (2 used) 8—Rollers 9—Synchronizing Shaft 10—Cylinder Block 11—Bearing Plate 03 0360 44 T8506AC –UN–10JUL95 TM1859 (14JUL04) 03-0360-44 700H Crawler Dozer Continued on next page CED,TX03399,5991 –19–28JUN02–5/11 071404 PN=234