John Deere 700H Crawler Dozer — Disassemble

Hydrostatic System TM1859 (14JUL04) 03-0360-49 700H Crawler Dozer 071404 PN=239 33. Inspect the bronze surface of the bearing plate (1) for damage and excessive wear. The sealing surfaces must be free from scratches and nicks. The locating pin holes must not be worn. Replace the bearing plate if damaged or worn. 34. Inspect the valve segment (2) sealing surfaces and spindle (3) for damage or wear. Check that the spindle is located correctly in the valve segment by measuring dimension “A”. If this dimension is not within the specification, the spindle has moved in the valve segment and the assembly must be replaced.

Specification Valve Segment Spindle Dimension “A”—Length........................... 39.4—39.6 mm (1.55—1.56 in.) 35. Inspect cylinder block (4) for wear or damage. The piston bores must be smooth. The bearing plate surface must be free from scratches or nicks, and the holes for the bearing plate locating pins must not be worn. The races for the synchronizing shaft rollers must not be worn. IMPORTANT: Remove speed ring ONLY if replacement is necessary. DO NOT damage sealing surface of cylinder block. 36. Place cylinder block on a clean soft surface (cardboard or shop towel) to replace speed ring. Be careful NOT to damage sealing surface of cylinder block. 37.

Remove speed ring from cylinder block by gently tapping on ring using a hammer and brass drift. 38. Place new speed ring on chamfered edge of cylinder block. 1—Bearing Plate 2—Valve Segment 3—Spindle 4—Cylinder Block 5—Cylinder Block Bearing –UN–12JUL95 T8506AF Continued on next page CED,TX03399,5991 –19–28JUN02–10/11 03 0360 49