John Deere 700H Crawler Dozer — Remove and Install

Remove and Install Park Brake Removal and Installation 1. Lower all equipment to ground. 2. Stop engine. Operate all hydraulic controls to release pressure in hydraulic system. 3. Turn battery disconnect switch to OFF. NOTE: Reservoir capacity is approximately 65.1 L (17.2 gal). 4. Drain reservoir or remove hydrostatic reservoir check valve and attach vacuum pump to elbow. 5. Remove hydrostatic motors. (See Remove and Install Hydrostatic Motors in Group 03-0300.) 6. Remove hub from park brake if not removed. 7. Remove brake assembly nuts and washers (1). 8. Remove park brake housing (2). OUO1065,0000459 –19–15NOV00–1/5 TM1859 (14JUL04) 11-1100-3 700H Crawler Dozer 071404 PN=321 9.

Remove park brake disks, plates and pressure plate (2). 10. Remove springs (3) and dowel pins (1). 11. Remove park brake piston and piston seals. –UN–17AUG00 12. Apply clean oil on seals and install seals on piston. 13. Install piston in housing. T133141B 1—Dowel pins 2—Park Brake Pressure Plate 3—Springs (20 used) –UN–17AUG00 T133145B Continued on next page OUO1065,0000459 –19–15NOV00–2/5 11 1100 3