John Deere 700H Crawler Dozer — Remove and Install

Control Linkage IMPORTANT: Support assembly so needle bearings (11) do not receive an impact when driving in pins (9 and 15). opposite end of spring over pin guide (19). Repeat steps for other side. 32. Rotate park lock lever to the locked position (up), while working pins (21) into pin guides (19). Rotate park lock assembly forward to the firewall and tighten cap screws (37). 24. Install cam (8) using pin (9) in orientation shown on illustration or as marked in disassembly. 25. Install bellcrank (14) using pin (15) in orientation shown in illustration or as marked in disassembly. Install pin flush in center of bellcrank. 33. Apply cure primer to threads of cap screw (3).

Apply thread lock and sealer (medium strength) and install lever down stop (5) onto bracket (12). 26. Clean threads of lever (2) and apply cure primer. Apply thread lock and sealer (medium strength) to threads and install knob (1) with symbols facing outward. 34. Rotate park lock lever to unlocked position (down) and install park lock linkage rod by connecting ball joint (33) to left side of bellcrank assembly (14) and yoke (29) to brake pedal as shown. Make sure step of yoke (29) faces as shown. 27. Install parts (16—19). Install pin guides (19) and pin (18) in direction shown. 35. Adjust park lock linkage assembly.

(See Park Lock Linkage Adjustment in Operation and Test Manual, Group 9026-20.) 28. Install switch (6) using socket head cap screws (7). 29. Install parts (21—24) on firewall anchor. Tighten nut and then back off 1/2 turn. 36. Test switch (6) using a continuity tester hooked up to the black and green wires of switch. Starting with park brake lock lever in the unlocked position (down), slowly move lever to the locked position (up). The switch should go from an to “closed” state before the lever is in the locked position (up). 30. Loosely install park lock assembly in machine using cap screws (37) and washers (16). 31.

With the park lock lever in the unlocked position (down) and the right side of the park lock assembly rotated toward the operator, place washers (16) and spring (20) over pin (21). Install 37. Install lower dash panel and instrument panel. 38. Turn battery disconnect switch to ON. 11 1115 6 CED,TX03399,6025 –19–28MAR00–4/4 TM1859 (14JUL04) 11-1115-6 700H Crawler Dozer 071404 PN=330