John Deere 700H Crawler Dozer — Remove and Install

Remove and Install Crossbar and Lube Lines Frame Installation 17 1740 1. Remove necessary covers. 10 2. Block and remove track chain. (See Remove and Install Lubricated Track Chain in Group 0130.) T131910B –UN–20JUN00 3. Raise crawler just enough to relieve weight on pin crossbar using a 9072 kg (10 ton) floor jack. Put shop stands under main frame. 4. Remove cover (1) to disconnect lube line on both sides. 1—Cover 2—Crossbar Side Pins (2 used) and Center Pin 3—Cap Screw (5 used) 5. Remove pin (2) on both sides and center. 6. Remove cap screws (3) on one side and remove crossbar support. CAUTION: The approximate weight of crossbar is 177 kg (390 lb). 7.

Attach a chain and hoist to crossbar and remove out the side. 8. Install crossbar and pins. 9. Install crossbar support, connect lube line and install cover. Tighten cap screws. 10. Install track chain. (See Remove and Install Lubricated Track Chain in Group 0130.) CED,TX03399,6033 –19–15NOV00–1/1 TM1859 (14JUL04) 17-1740-10 700H Crawler Dozer 071404 PN=392