Removal and Installation 20. Connect wiring harnesses (B) to transmission controller (C). 21. Install clamp (D). Tighten cap screw to specification. Cab/ROPS—Specification Transmission Controller Clamp Cap Screw—Torque 73 (54 lb-ft) ........................................................ T116728C –UN–20AUG98 22. Install transmission controller cover (A). A—Transmission Controller Cover B—Wiring Harnesses C—Transmission Controller D—Clamp T116756B –UN–21AUG98 TM1859 (14JUL04) 18-1800-13 700H Crawler Dozer Continued on next page CED,TX03399,6047 –19–14APR03–10/11 071404 PN=411 19. Connect five wire connectors (1—5) to single lever controller (SLC). 1—B5 Left And Right Steer Sensor.
(Marked BLUE on housing below sensor.) T10 Blue, T11 Blue, Z05 Gray Wires 2—B2 FNR Sensor. (Marked YELLOW on housing below sensor.) T01 Blue, T02 Blue, Z01 Gray Wires 3—S3 Neutral Start Switch. E09B White Wire, E03B White Wire 4—B4 Transmission Speed Control Sensor. T07 Blue, T04 Blue, Z04 Gray Wires 5—Horn Connector –UN–16MAY00 T130917B CED,TX03399,6047 –19–14APR03–9/11 18 1800 13