Track System Measure Carrier Roller Wear NOTE: See Undercarriage Appraisal Manual SP326 for additional information. T5819AC –UN–01NOV88 Item Measurement Specification Carrier Roller New Carrier Roller OD 171.5 mm (6.75 in.) 100 Percent Worn Carrier Roller OD 158.5 mm (6.24 in.) 1. Position an outside calipers over the most worn area of roller running surface, and close until caliper tips just touch tread surface. 2. Measure caliper tip spread using the scale to the nearest 0.5 mm (0.002 in.). 3. Check for flat spots on carrier roller thread, which indicate roller is not free to turn.
TM1859 (14JUL04) 01-0130-11 700H Crawler Dozer CED,TX03399,5936 –19–03APR01–1/1 071404 PN=61 1—Track Frame Assembly 6—Washer (13 used) 11—Cap Screw (2 used) 16—Cap Screw (4 used) 2—Cap Screw (4 used) 7—Cap Screw (6 used) 12—Washer (4 used) 17—Nut (2 used) 3—Washer (8 used) 8—Cap Screw (3 used) 13—Rear Rock Guard 18—Rear Rock Guard 4—Rock Guard 9—Nut (4 used) 14—Spacer (2 used) 19—Rock Guard Assembly 5—Spacer (4 used) 10—Cap Screw (4 used) 15—Washer (4 used) 1. Use a chain and hoist when removing rock guards. CAUTION: The approximate weight of Inspect parts, replace if necessary. standard rock guard is 58 kg (129 lb) and rear rock guard is 24 kg (53 lb). 2.
Apply thread lock and sealer (medium strength) to all cap screws except (2 and 11). Tighten cap Rock Guard—Specification screws. Rock Guard—Weight............................... 58 kg (129 lb) Approximate Rear Rock Guard—Weight........................ 24 kg (53 lb) Approximate CED,TX03399,5935 –19–24MAR00–2/2 01 0130 11