John Deere 700H Crawler Dozer — Disassemble and Assemble

Track System TM1859 (14JUL04) 01-0130-13 700H Crawler Dozer 071404 PN=63 Disassemble and Assemble Carrier Roller 1. Remove bracket from carrier roller (if removed). 2. Remove cap screws (H) and cover (I). 3. Drain oil from housing. 4. Remove cap screws (J) and retainer plate (G) from shaft (K). 5. Press outer bearing cone (F) and shaft (K) out of roller shell (B) using a press. 6. Press inner bearing cone (L) from shaft. Bearing is a press fit. IMPORTANT: Metal face seals can be reused if they are not worn or damaged. A used seal must be kept together as a set because of wear patterns on seal ring face. –UN–20MAY95 7. Remove snap ring (D), seal retainer (C) and metal face seals (E).

Keep seal rings together as a matched set with faces together to protect lapped surfaces. Inspect T8401AB metal face seal. (See Inspect Metal Face Seals in this group.) A—Bearing Cup (2 used) 8. Remove bearing cups (A). Inspect roller shell for B—Roller Shell grooved, burred or galled condition. C—Seal Retainer D—Snap Ring E—Metal Face Seal 9. Replace parts as necessary. F—Bearing Cone G—Retainer Plate H—Cap Screw (3 used) I—Cover J—Cap Screw (2 used) K—Shaft L—Bearing Cone M—O-Ring Continued on next page CED,TX03399,5938 –19–24MAR00–1/3 01 0130 13