Track System 16. Advance left ram until left link contacts saddle. Advance right ram until it stops (plungers in both rams against shim pack). 01 0130 A—Left Ram B—Saddle C—Pin D—Plunger E—Right Ram F—Right Link G—Bushing H—Shims I—Left Link 42 T96282 –UN–27OCT88 T96283 –UN–27OCT88 CED,TX03399,5953 –19–24MAR00–10/14 NOTE: To ensure zero end play in joint, special spacers must be fabricated using a section of bushing. 17. Retract left ram. Install special spacer (A) between the joint in rear seat of saddle and ram. IMPORTANT: Too much pressure will crush the thrust rings. T96284 –UN–27OCT88 18. Advance left ram using only minimum force required to push joint tight.
Pressure must be approximately one-half the relief valve setting. Remove spacer. A—Special Spacer Continued on next page CED,TX03399,5953 –19–24MAR00–11/14 TM1859 (14JUL04) 01-0130-42 700H Crawler Dozer 071404 PN=92