. OPERATION OPERATION OPERATION OPERATION 2. The screen displays the method for carrying out calibration. When carrying out calibration, tilt back the bucket when it is empty and raise it from the bucket travel posture to the maximum height. When this is done, the measurement is automatically made. (Approx. 15 seconds) 3. After the automatic measurement is carried out, the CAL screen automatically returns to the original screen. If it is desired to return to the original screen without carrying out calibration, press the [Return] switch (F1) at the bottom of the screen. LOADMETER SUBTRACTION MODE LOADMETER SUBTRACTION MODE SCREEN DISPLAY 1.
Press the [SUB] switch (F2) at the bottom of the LOAD METER ADDITION MODE screen. 2. The screen switches to the LOAD METER SUBTRACTION MODE screen. This screen consists of kind of material display (1), remaining amount display (2), load display (3), return switch (F1), addition mode selector switch (F2), total load display switch (F3), positioner screen selector switch (F4), failure list screen selector switch (F5), and [load meter subtraction mode setting screen] selector switch (F6). The load for each bucket is measured and is subtracted from the target value already set for the subtraction standard setting, and this is displayed on the screen.
However, this is only when the screen is set to the subtraction mode screen. 3 - 140 (PRECAUTIONS WHEN OPERATI NG SUBTRACTION MODE) The load in the bucket is measur ed and the remaining load is displaye d, but if the remaining loa d in the subtraction mode is a negative value, the m ethod with the subtraction mode is as follows. 1) The remaining load is di sounds intermittently. 2) After that, the remaining displayed.
(It returns to the value be 3) From this condition, load 4) Raise and lower the lift a 5) Load the dump truck with number (red display), the splayed in red (to indicate a negative value) for 3 seconds an d the alarm buzzer load changes to a yellow display and the load remaining to the target value is fore the last bucket was measured.) the dump truck with only an amount that matches the target value. rm again to measure the remaining load again. fore the last bucket was measured.) the dump truck with only an amount that matches the target v rm again to measure the remaining l oad again. the load in the bucket.
When the re maining load value becom es 0 or a negative alarm buzzer sounds intermittently.