. OPERATION OPERATION 6) load for the next dump truck. 7) LOADMETER SUBTRACTION STANDARD SETTING DISPLAY 1. If it is desired to change the standard value displayed on the screen, press [LOAD METER SUBTRACTION MODE SETTING] selector switch (F6) on the LOAD METER SUBTRACTION MODE screen. 2. The screen changes to the LOAD METER SUBTRACTION MODE SETTING screen. Use switches (F3) or (F4) to select [Remaining] displayed on the screen, then confirm the selection with [SEL] switch (F6). 3. The screen changes to the Remaining data set screen. Use switches (F3) or (F4) to select the numbers for the new target value for remaining data, then input the selection with [SEL] switch (F5).
If the wrong number is input, use [CLEAR] switch (F2) to cancel the input numbers one by one. Continue to input the numbers until all the numbers of the target value for remaining data have been input. The maximum value for the remaining data is 65535. Even if any value above that is input, 65535 will be input. 4. PRESS [ 3 ] switch (F6). This completes the input of the target value for the remaining data, and the screen returns to the LOAD METER SUBTRACTION MODE SETTING screen. 3 - 141 at the top of the console on the righ t side of the operator's seat ON (the remaining d in the bucket subtracted from the target value), and load the bucket as the first uck.
et and starting new loading, turn the cancel switch on the side of the bucket control ds of measuring the bucket load, t he n empty the bucket. OTHER DISPLAYS The following display selector switches are shown on the LOAD METER SUBTRACTION MODE screen, but these switches are the same a s for the items already explained for th e LOAD METER ADDITI ON MODE screen. Total load display switch (F3) itch (F4) Positioner screen selector sw Return switch (F1) [KIND] and [CAL] are displaye d on the LOAD METER SUBTRACTION MODE screen, but t hese switches are the same as for the items alre ady explained for the LOAD METER ADDITION MODE scree n.