Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING 3 - 162 It is da ngerous to charge a battery whe n installed on a machine. Make sure th at it is removed before charging . When c hecking or handling the batter y, stop the engine and turn the starting switch key to OFF position. The bat tery generates hydrogen gas, s o there is a hazard of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause s parks. Battery electrolyte is dilute sulfuric aci d, and it will attack your clothes and ski n. If it gets on your clothes or o n your skin, immediately wash it off with a large amount of water.

If it ge ts in your eyes, wash it out with fresh w ater and consult a doctor. handling batteries, always wear safety glasses and rubber When gloves. When r emoving the battery, first disco nnect the cable from the ground (norma lly the negative (-) terminal). Wh en installing, install the positive (+) term inal first. If a too l touches the positive terminal a nd the chassis, there is danger that it w ill cause a spark, so be extrem ely careful. If the te rminals are loose, there is dange r that the defective contact may generat e sparks that will cause an expl osion.

When r emoving or installing the termin als, check which is the positive (+) term inal and which is the negative ( -) terminal. REMOVAL AND INSTALLATION OF BATTERY ve the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remo ve the ground cable (normally connected to t he negative (-) terminal). If any t ool touches between the po sitive terminal and the chassis, there is a hazard of spark s being generated. When installing the battery, conne ct the ground cable last. REMARK There ar e 3 batteries each (total: 6) o n both sides at the rear of the machine