. OPERATION TROUBLESHOOTING STARTING ENGINE WITH BOOSTER CABLE When starting the engine with a booster cable, do as follows. PRECAUTIONS WHEN CONNECTING AND DISCONNECTING BOOSTER CABLE WARNING 3 - 163 PRECAUTIONS FOR CHAR GING BATTERY e battery is not handled correctly, may explode. Always follow the GE 3-154)" and the instruction ger, and do as follows. tery if the battery electrolyte level ine. This may cause an explosion. level periodically and add distilled level to the UPPER LEVEL line. to match the voltage of the battery oltage is not selected, the charger explosion. When charging the battery, if th e battery is not handled correctly, there is danger that the battery may explode.
Always follow the instructions in "BATTERY (PA GE 3-154)" and the instruction manual accompanying the char ger, and do as follows. Do not use or charge the bat tery if the battery electrolyte level is below the LOWER LEVEL l ine. This may cause an explosion. Check the battery electrolyte level periodically and add distilled water to bring the electrolyte level to the UPPER LEVEL line. Set the voltage of the charger to match the voltage of the battery to be charged.
If the correct v oltage is not selected, the charger may overheat and cause an Connect the positive (+) char ger clip of the charger to the positive (+) te rminal of the batt ery, then connec t the negative (-) charger clip of th securely. e charger to the negative (-) terminal of the battery. Be sure to attach the clips clips Set the charging current to 1/ 10 of the value of the rated battery capacity ; when carrying o ut rapid charging , set it to less than the rated batter y capacity. If the charger current is too h igh, the electrolyte will leak or dry up, and t his may cause th e battery to catch fire and explode.
If the battery electrolyte is fro zen, do not charge the battery or start the engine with a different power source. ll ignite the battery electrolyte and cause the battery to explode. There is a danger that this wi ll ignite the battery electrolyte and cause t he battery to expl When connecting the cables,nev er contact the positive (+) and negative (-) terminals. When starting the engine with a b ooster cable, wear safety glasses and rubber gloves. Be careful not to let the normal m achine and problem machine contact each other. This prevents spar ks from generating near the battery which could ignite the hydrogen Make sure that there is no mista gas given off by the battery.
ke in the booster cable connections. The final connection is to the eng ine block of the problem machine, but sparks will be generated when th is is done, so connect to a place as far as possible from the battery. When disconnecting the booster cable, take care not to bring the clips in contact with each other or wit h the machine body. NOTICE ip of a thickness that is suitable for the size of the battery. Always use a booster cable or cl ip of a thickness that is suitable for th e size of th For the battery on the normal ma chine, use a battery with the same capacity as t he problem machin Check that the cable and clips ar e not damaged or corroded.
rking brakes of both machines are at the LOCK position. utral position. Connect the clips securely. Check that the lock levers and pa rking brakes of both machines are at the LOCK Check that all levers are at the ne