Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE 4 - 21 CLEANING OR REPLACING OUTER ELEMENT 1. R emove win g nut (1), then r emove outer element (2 2. Cl ean the in side of the air cl 3. Di rect dry co mpressed air (le ss than 0.2 M Pa {2.1 kg /cm2 , 30.0 , then P di 1 2 3 4 SI}) to the outer element from inside a long its f olds rect it from outside along i ts folds and a gain from inside. ) Remove 1 seal from th cleaned. e element whenever the element has been ) Replace the outer elem ent if it has be en cleane d 6 times repeated element ly or used thro ughout a year. Replace the inner e.

ging warning display is given uter element has been cleaned, inner at the same tim ) If the a ir cleaner clog immedia even wh both the tely after the o en it has not b uter element has been een cleaned 6 times, replace the elements. ounting nuts for looseness and, if place the inner and outer ) Check in ner element m necessa ry, retighten. 4. If small hole s or thinner part s are found o n the element when it i th s checked by shining a ligh t through it aft er cleanin g, replace e element. 5. If seal washe r (4) is damage d or the thread of nut (3) is broken, re place with new parts.

NOTIC E When cleaning the element, do not hit or beat it aga inst anythi Do not use an elem ent whose folds, gasket or seal are damage 6. S et the clea