Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECK AXLE OIL LEVEL, ADD OIL WARNING 4 - 27 The parts and oil are at high temperature imme diately after th e engine is stopped, and may cause burns. Wait for the temperature to g o down before s Perform this proc edure if there is any sig n of oil on the axle ca Inspect the machi ne on a horizontal surf ace. (If t he road surfac e is at an angle, the oil level cannot be check correctly.) ne and remove level plug (1). 1. Stop the engi ne and remove level pl 2. Check that th e oil level is near the b ottom of the p lug hole. 3. If the oil is not near the bottom edge of the hole, a dd oil thr ough 4.

If the oil level is correct, install level Tightening tor que: 127 to 177 Nm (1 3.0 to 18.0 kg m, 94.0 CLEAN AXLE CASE BREATHER Remove all mud a nd dirt from around th e breather wit h a brus After removing th e mud or dirt from arou nd the breath er, remo the breather, imm erse it in cleaning fluid When cleaning th (front and rear). After removing the breather, take steps to prevent dirt o r dust fro entering the moun t.