. MAINTENANCE SERVICE PROCEDURE CHECK TRANSMISSION OIL LEVEL, ADD OIL WARNING 1. Start the engine and run it at low idle. 2. Remove cap of oil filler (F). 3. When the oil is warmed up (approx. 40 - 60 ° C (104 - 140 ° F)), check the oil level with sight gauge (G). If the oil is inside bottom area B of sight gauge (G), the oil level is correct. 6. If the oil level is correct, then tighten the cap. 4 - 26 The parts and oil are at high te mperature immediately after the engin e is stopped, and may cause burns . Wait for the temperature to go down before starting the Carry out this procedure if t here is any sign of oil on the transmission case, or if there is oil mixed with the cooling water.
Before starting the engine, check that the oil is in area A at t he top of sight gauge (G) or be tween top area A and bottom area B. When changing the oil, suc h as when changing the transmission oi l or when the transmissi on has been replaced, add oil first to area A at the top of sight gauge (G). re below to check the oil level. After that, use the procedu 4. If the oil does not reach bottom area B of sight gauge (G) , add oil through oil filler port (F). 5. If the oil is above botto m area B of sight gauge (G), remove drain plug (1), loosen then check the oil level drain valve (2) to drain the excess oil, again. il,