Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM BRAKE HYDRAULIC CIRCUIT 4 - 36 After removin g the piping of brake hydraulic circuit,blee d the air from inside of the circuit a 1. A fter ass embling the piping ,be sure to check that the onnector s are not loose. s under the wheels. 2. P ut block 3. U se sight gauge (G) at the re ar of the brake oil tank to c heck at the oi l is up to the specifi 4. R emove t he air bleeder cap fr om the brake housing and in sert o e ne end o f a vinyl hose in the brake housing and put the o ther nd in a c 5. D epress bl p eed air. edal slo This w depres throug h the bleeder screw Use th e left-hand brake pe Supply high. 6.

R epeat th is operation until air out o f the ti ghten bl eeder screw (1) whil e the oil is flowing out. 7. B leed the air at all 4 locations ( 4 wheels). After bleeding th e air , check the oil level in the brake oil tank, and add oi l if the le vel is low. One leeds Then, depress th e pedal to the end and BLEEDING AIR FROM PPC CI RCUIT When removi ng piping of PPC circ uit, or removing strainer, af ter assembling, bleed air from inside of the circuit as follow s: 1. P st 2. P re 1. P ut bucke t control lever in TIL T position and lift arm contr ol lever in FLOAT position, an d after cylinder reaches roke en d, keep in that positi on for one minute.

UMP position and lift arm control lever in RAISE position, and after cylinder at position for one minute. distributor. 2. P ut bucke t control lever in D contro aches s troke end, keep in th at position for one minute. For d etails, co ntact your Komatsu