Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM HYDRAULIC CIRCUIT (PAGE 4-45)". 4 - 40 NOTIC When b leeding the air, if the engine is run at high speed from the start , or t he cylinder is op erated fully to the en d of its stroke, the a ir inside the cylinder may damage th Always do as follows when bleeding 1. Check that the hydraulic oil i n the hydraulic tank is at the specified le vel. 2. Start the engine, run at low id ling for approx. 5 minutes, then check th at ther e is no oil leakage from any place. 3. Run the engine at low idle, an d extend and retract the steering, bucket, and lift arm cylinders 4 to 5 times.

Be careful not to operate the cylin der to the end of its stroke (stop approx. 100 m m (3.9 in) before th e end of stroke). 4. Next, operate the steering, b ucket, and lift arm cylinders full to the end of their stroke 3 or 5. Bleed the air from air bleed p Loosen plug (1), and when oil flows from the plug hole and the air has been completely rem 6. Check the hydraulic oil level and ensure that is correct, Refe to OIL 7. Next, raise the engine speed (approx. 1500 rpm) and repeat th e air bleed o peration in Steps Repeat this operation until no more air comes out from plug (1). 8. After completing the air bleed operation, tighten plug (1). Tightening torque: 9.8 to 12.

8 Nm (1.0 to 1.3 kgm, 7.2 to 9.4 lbf 9. Check the hydraulic oil level and ensure that is correct, Refe r to "CHECK O IL LEVEL IN HYD RAULIC TANK, ADD OIL (PAGE 4-45)". REPLACE ETHER CARTRID If the ether cartridge is empty, re place it with a new cartridge