Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR INSIDE PISTON PUMP (3) installed to the piston pump. (Loosen one to the pressurizing air hose to pressurize the NOTICE To prevent the oil from spurting out, pressurize the hydraulic tank gradually. 4 - 39 1. Loosen pl place at a 2. Supply ai hydraulic t 3. When oil fl ows from t he plug hole and the a ir has been completely r emoved, tighten plug (3). Repeat the same procedure to bleed t he air from th e other l ocations. There is a plug in the suction tube of each pump, so carr y ou t the bleeding operation f or all plugs (4 places). REMARK If all 4 plugs a re loosene d at t he sam e time, o il will spurt out, so b leed the air from 1 plug a 4.

Check the hydraulic oil level, and add oil i f the oil lev el is low. 5. Remove th e pressurizing air hose fro m the hydraulic t ank and install plug