Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE piston pump, work after completing the BLEEDING AIR FROM TUBE ON SUCTION SIDE the suction side of the 2. Supply air to the pressurizing air hose to pressurize the hydraulic tank. NOTICE To prevent the oil from spurting out, pressurize the hydraulic tank gradually. 3. When oil flows from the plug hole and the air has been REMARK If all 4 plugs are loosened at the same time, oil will spurt out, so bleed the air from 1 plug at a time.

4 - 38 BLEEDING AIR FROM HYDRAULIC T After changing, r eplacing or cleaning the oi l, filter element, o r strainer , bleed the air from i If the oil or elem ent in the hydraulic tank has been replaced, or equipment, or pi replacement ope When bleeding th e air, bleed the air from th e piston pump fir st, then b leed the air from the BLEEDING AIR FROM PISTON PUMP NOTICE NOTICE If the air is not blee d completely, the piston pum p may be damaged, so always carry out the air bleed Before bleeding the air from the piston pu mp, check that th e hydraul ic is filled with oil up to the top of the sight gauge.

(If the oil l evel is low, add oil.) The c ap of the hydrauli c tank remains removing, unti l the air bleeding of the piston pump finis hes. Remove plug (1) at the top of the hydraulic tank, then connec t the pressurizing air h ose. PT1/8 Plug thread size: 1. Loosen plug (2) on top of the tube at t (Loosen one place at a ti completely r procedure to There is a plu the bleeding bleed the air from the oth g in the suction tube of ea ch pump, so carr y out operation for all plugs (4 p laces).