Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK, ADJUST DENSITY OF COOLING WATER ADDITIVE WARNING There is an expiry date for the test kit, so stock a suitable number to match the frequency of use. button on radiator cap (2) to 4 - 52 Immediately after the engine is stoppe d, the cooling water is at high temperature a nd the radiato r is under high internal pr essure. If the radiator cap is removed in this condition and the water is drained, it ma y cause burns. To prevent this, wait for the . temperature to go down, then turn the cap slowly to release the internal pressure 1. Prepare cooling water additiv Density test kit Cummins Part No. CC2602 (c CC2602A CC2602B Density test kit Cummins Part No.

CC2602 (c 2. Push the pressure reduction release the pressure, then re 3. Remove a small amount of co olant from the radiator and measure th e density of t he additive wi th a dens ity test kit. For details of the method of measuring, see the instructions pro vided with t he test kit. 4. Considering the results of the measurement, decide the method of adjusting th e density of th e cooling water additive, then carry out the ad 1) If density is less than 1.2 Replace the corrosion For details of the repl (PAGE 4-53) and CLE 2) If density is 1.2 - 3 (unit/g Replace only the corro For details of the repl (PAGE 4-53).

3) If density is more than 3 ( Do not replace the corr If the density is below additive, then carry out the ad justment. (unit/gallon) resistor, then replace with coolant of the specified additive density.

1) If density is less than 1.2 Replace the corrosion resistor, then replace with coolant of t he specified additive dens acement procedure, see REPLACE CORROSIO AN INSIDE OF COOLING SYSTEM ( PAGE 4-23) 2) If density is 1.2 - 3 (unit/g Replace only the corro 3) If density is more than 3 ( Do not replace the corr 3 (unit/gallon) at the following inspecti on, replace t he corrosion r NOTICE If the density of the cooling water addit ive is low, it will cause pitting of the liner an d corrosion of the cooling sys tem. On th e other hand , if t he density is too high, it will cause leakage from the water pump seal.