. MAINTENANCE SERVICE PROCEDURE or any to tension when out of the a tension, 4 - 53 REPLACE CORROSION RESISTOR CARTRIDGE NOTICE NOTICE Replace the corrosion resis tor cartridge only when necessary. Fo r details, see CHECK, ADJUST DEN SITY OF COOLING WATER ADDITIVE (PAGE 4-52). 1. Open the engine sid e cover located on the right of the hood. 2. Set valve (1) of the close it. corrosion resistor to the OFF pos 3. Using a filter wrench , turn cartridge (2) to the left to rem 4. Clean the surface o f the filter holder and the area arou filter holder. If the cartridge seal is left on the filter holder, remove it 5. Apply oil to the seali ng surface of a new cartridge, then it to the filter holder.
6. When installing, brin g the seal into contact with the filte r holder seal surface, then tigh ten a further approx. 1/2 - 3/4 turns. ON position to open it. check that there is no leakage of water from the cartridge seal surface. 7. Set valve (1) to the 8. Start the engine and check that there is no leakage of water from the cartridge seal s CHECK, ADJUST FA N BELT for any cracks, wear, cuts, tears, any problem is found, it is neces 1. Check fan belt (1) other problems. If replace the fan belt, out the replacement 2. Use belt tension ga belt (1) at a midpoin Specified value for (reading of tension 3. Adjust the belt tensi If rod (3) is turned increases.
If the specified te adjusting the rod, a inspection and main so ask your Komatsu distributor t . uge (2) to measure the tension of t 2. Use belt tension ga t between the pulleys. belt tension: 5300 N (544.3 kg) gauge) on to the specified value. in the direction of the arrow, the t nsion cannot be reached even sk your Komatsu distributor to ca tenance. CHECK ALTERNATO R DRIVE BELT ve belt, and replace the belt if any ound. ped with a belt tensioner to mai Check the alternator dri following problems are f constant tension, so it i s unnecessary to adjust the belt te ation of the belt. regardless of any elong