Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST ADJUSTING 4 - 55 CHECKING The deflection when pressed should be approx. 12.5 to 16.5 mm (0.5 to 0.7 in) The whe with a finger force of approx . 98.1 N (10 kg) at a point midway b etween the air conditioner co mpressor pulley and drive pulley. Whe of 35 n using a b 3 to 530 N elt tension gauge, the tension (36 to 54 kg). should be in a range CHECK WHEN CHANGING THE V-BELT The deflection should be approx. 9 to 12.5 m m (0.355 to 0.5 in) whe n pressed with a finger force of approx. 98.1 N (1 0 kg) at a p oint midway between the air conditioner compresso r pulley and drive pulley. 54 to 76 kg).

Whe n using a b elt tension gauge, the tensio n should be in a range of 530 to 745 N ( 1. L oosen bolt 2. L oosen loc 3. T urn adjust ment bolt (3) and adjust the b elt tension so that the deflection is the standard value. Deflection when checking: (approx. 98.1 12.5 to 16.5 Deflection when replacing: (approx. 98.1 to 12.5 mm ( 4. After adjusting, tighten locknut (2). eflection is 5. T ighten bol 6. C heck eac w V ear of the -belt is no t in contact with the bottom o 7. I f the belt h as elongated and there is no more allowance for adjustment, or if the b elt is cut or cracked, replace t I o he belt.

f the V-belt has been replaced with a new part, there will be initial elongation, so in spect and adjust it again after ne-hour of operation.