Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE specified level. For details, see CHECK BRAKE OIL TANK LEVEL, ADD OIL (PAGE 3-81). 4 - 61 6. Remove the mounting bolt s of cover (10) on the top surface of the brake oil tank, then re hold the cover down when cover from flying off under move the cover. When doing this, removing the bolts to prevent the the force of spring (11). 7. 8. Remove spring (11) and element (13). Check that there is no fo bypass valve (12), then take out reign matter inside the tank, then k. clean the inside of the tan 9. Install a new element, then set bypass valve (12), spring (11), and cover (10) in the brak cover O-ring is damaged e oil tank.

When doing this, or deteriorated, replace the O if the -ring. Also, be careful that the assembling. Hold down cover (10) O-ring does not come out when and tighten the mounting bolts when 10. bolts 11. Remove the mounting bolt s of cover (14) on the top surface of the brake cooling oil tank, t this, hold the cover down the cover from flying off un hen remove the cover. When when removing the bolts to pr der the force of spring (15). doing event 12. 13. Remove spring (15) and element (17). Check that there is no fo bypass valve (16), then take out reign matter inside the tank, then k. clean the inside of the tan 14.

Install a new element, then set bypass valve (16), spring (15), and cover (14) in the brake cooling oil tank. When doin g this, if aged or deteriorated, replace the 16. Add engine oil through oil f illers (F) to the specified level , then 17. install plugs (2) and (3) in Install the oil filler caps. the center of the filter cover.