. MAINTENANCE SERVICE PROCEDURE LUBRICATING TIGHTEN ROPS 4 - 68 1. Usin g a grease p ump, pum p in grease through the grease fittings marked by the arr 2. After greasing, w ipe off any old grease that was pushed out. (1) Front drive shaft ( (2) Rear drive shaft ( (3) Uppe r driv e shaft (3 places) Check th at ROPS. If any bolt is l oose, tighten i Tightening torque: 45 00 to 550 0 N 59 to 561 kgm , 3319.9 to 4 057.7 lbft) The tightening torque is large, s o a power wrenc h is needed when tightenin quest your distributo carr out this work