Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING stopped, and may cause burns. Wait for the ring from breather (1), then remove the element with a new part, then install the 4 - 73 T ediately emperature to go down before starting the work W hen removing the oil filler cap, turn it slowly to release the intern al pressure the engine 1. Remove the ca 2. Remove the sn breather cap. 3. Replace the filt breather cap an 4. Tighten the cap REMARK I t is possible to repl ace the element w ith the breathe r installe d in the tank.

However , if the breather is breather with s remove d, do n ot wrap the taper thread of the eal tape when assembling assembling again, and be caref ul not to tighten to o much. CLEAN PPC CIRCUIT STRAINER 1. 2. 3. 4. 5. 6. 1. Remove filter c 2. Take out the st clean light oil or If the strainer is 3. 4. Install the strain Put bucket con er and filter case trol lever in TILT lever in FLOAT position, and aft er cylin end, keep in tha t position for one minute. 5. Put bucket cont rol lever in DUMP position and lift arm control lever in RAISE p osition, and after cylinder reaches stroke e nd, keep in that pos ition for one minu 6. Bleed the air fro m the hydraulic cir cuit.

Fo r details , see "BLEEDING AIR FROM PPC C IRCUIT (PAGE 4-36)".