Komatsu — SWITCHES

.

OPERATION EXPLANATION OF COMPONENTS (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15) (16) (17) (18) Starting switch Lamp switch Travel speed limit dial Drive force limit dial Load meter cancel switch Travel speed limit ON-OFF switch Transmission auto shift, manual selector switch Kick-down switch Turn signal switch Left power window switch Right power window switch Cigarette lighter RPM set ON-OFF switch RPM set idling up-down selector switch Load meter sub-total switch Hazard lamp switch Parking brake switch Ether spray switch (19) (20) (21) (22) (23) (24) (25) (26) (27) (28) (29) (30) (31) (32) (33) (34) (35) Horn switch Shift-down switch Shift-up switch Directional selector switch Front working lamp switch Rear working lamp switch Transmission cut-off switch Engine hood side lamp switch Step lamp switch Rear wiper switch Wiper selector switch Front wiper switch Auto grease switch Tire slip control ON-OFF switch Room lamp switch Engine room lamp switch Emergency parking brake release switch STARTING SWITCH This switch (1) is used to start or stop the engine.

OFF position The key can be inserted and removed at this position. When the key is turned to this position, all electrical circuits are turned off and the engine stops. In addition, the parking brake is automatically applied. ON position In this position, electric current flows to the charging circuit, lamp circuit, and accessory circuit. Keep the starting switch key at the ON position while the engine is running. START position This is the position for starting the engine. When the starting key is turned to the START position, the prelube indicator lights up, prelubrication starts, and the engine starts. After the engine starts, return the starting key to the ON position.

After lubrication, the starting motor turns and the engine starts. In cold weather, if it is difficult to start the engine, spray ether into the intake manifold at this position. For details of the method of using ether, see STARTING IN COLD WEATHER (PAGE 3-93). REMARK "Prelube" means forcible feed of oil to all parts of the engine before cranking of the engine starts. This prevents any loss of the oil film at rotating parts of the engine. 3 - 28