. OPERATION OPERATION ADJUSTING WORK EQUIPMENT POSTURE WARNING down. 3 - 136 Stop the machine on flat ground, position while stepping the brake pull parking brake lever to the LOCK pedal, then make sure the machine is completely stopped. Put blocks under the front and the rear of the tires. with the frame lock bar. he work equipment control lever. Secure the front and rear frames Always attach the warning tag to t Do not go under the work equipme the work equipment securely, use nt when the arm is raised.
To support a strong support that can withstand the weight of the work equipmen t and prevent the arm coming from The boom kickout makes it pos sible to set the bucket so that it automatically stops at the desire d lifting height (lift arm higher than horizontal) and the bucket positi oner makes it possible to set the bucket so that it automatically st ops at the desired digging angle. The setting can be adjusted to m atch the working conditions. ADJUSTING BOOM KICKOU T d height, set the work equipment et the work equipment lock lever p the engine.
the position of plate (2) so that the the center of the sensing surface tighten the bolts to hold the plate a clearance of 3 to 5 mm (0.118 (2) and the sensing surface of ghten the nuts to hold in position. .6 Nm (1.5 to 2.0 kgm , 10.8 to gine and operate the work equipment control lever. Check that the lever is LD when the bucket reaches the desired height. f returning the control lever automatically to the HOLD position, see "WORK VER (PAGE 3-57)". 1. Raise the bucket to the desire control lever at HOLD, then s to the LOCK position and sto 2. Loosen 2 bolts (1) and adjust top of the plate is aligned with of proximity switch (3). Then in position. 3.
Loosen two nuts (4) to make to 0.197 in) between plate proximity switch (3). Then ti Tightening torque: 14.7 to 19 14.5 lbft) 4. After adjusting, start the en automatically returned to HO For details of the method o EQUIPMENT CONTROL LE 1. Raise the bucket to the desire d height, set the work equipment et the work equipment lock lever 3. Loosen two nuts (4) to make a clearance of 3 to 5 mm (0.118 (2) and the sensing surface of ghten the nuts to hold in position.