. OPERATION OPERATION 3 - 137 ADJUSTING BUCKET POS 1. Lower t he bucket to the angle, r eturn the work equ ipment control lever to HOLD, then set the sto p the 2. Set the attachment select or switch to bucket posit 3. Loosen nut (1), then adjus t the position of the prox imity switch so t hat the rear tip of bar (2) is in line with the center of the ity switch (3). clearance between bar (2) and the mity switch (3) is 3 to 5 mm, then osition. 19.6 Nm (1.5 to 2.0 kgm , 10.8 to t) st so that the tip of protector (5) m the sensing surface of proximity bolt to hold in position. gine and raise the lift arm. Operate the sensing surface of proxim 4.
Adjust nut (1) so that the sensing surface of proxi tighten the nut to hold in p Tightening torque: 14.7 to 14.5 lbf 5. Loosen bolt (4) and adju sensing surface of proxi tighten the nut to hold in p Tightening torque: 14.7 to 6. extends 0.5 to 1.0 mm fro of proximity m. Operate switch (3), then tighten the After adjusting, start the en bolt to hold in position. gine and raise the lift ar the bucket control lever to the DUMP position, the n operate it to the TILT BACK posi automatically returned to t tion and check that t he HOLD position when he lever is the bucket reaches the desired diggin g angle.