Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEANING WITH ENGINE SIDE COVER OPEN 1. Open the engine side covers on the left and right sides of the machine. 2. Remove mounting bolts (2) (two places at top) of condenser (1). 3. Hold the top of condenser (1) and tip it over to the front. 4. Insert the steam jet nozzle through the gap between the radiator, oil cooler, aftercooler (3) and the air conditioner condenser (1), and carry out cleaning. 5. Use an air jet nozzle to blow out to the front of the machine all the mud and dirt that has dropped down. Use an air jet nozzle also to blow out to the front of the machine the mud and dirt that has accumulated on top of the fuel tank.

It is also possible to use steam or water in place of compressed air. 6. Return condenser (1) to its original position and install bolts (2). TURN, REPLACE BOLT-ON CUTTING EDGE WARNING 4 - 32 It is dangerous if the work equipmen t moves by mistake during the turning or replacement operation. Set the work equipment in a stable condition, stop the engine, then set the work equipment lock lever securely to work e ver securely to the LOCK position. Turn or replace the cutting edge before the wear reaches the edge of the b 1. Raise the bucket to a suitable the bucket to prevent the buc Raise the bucket so that the horizontal. 2. Remove nuts and bolts (1), t 3. Clean the mounting surface 4.

Turn cutting edge (2) and ins the edge, install it to the opp right edge to left side). If both sides of the cutting ed part. If the wear extends to the mounting surface before inst 5. Tighten nuts and bolts (1) un Tightening torque for mounti 6. Tighten the mounting bolts a 1. Raise the bucket to a suitable 6. Tighten the mounting bolts a gain after operating for several hours 5. Tighten nuts and bolts (1) un iformly so that there is no gap between the bucket and cu