Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 107 Lubrication System Lubrication System Perform the following procedures in order to inspect the oil pump. Refer to Specifications, “Engine Oil Pump” for clearances and torques. i03994210 Engine Oil Pressure - Test Low Oil Pressure The following conditions will cause low oil pressure. The oil level is low in the crankcase. A restriction exists on the oil suction screen. Connections in the oil lines are leaking. Illustration 101 g00938064 Typical example The connecting rod or the main bearings are worn. The rotors in the oil pump are worn. 1. Remove the oil pump from the engine. Remove the cover of the oil pump. The oil pressure relief valve is operating incorrectly. 2.

Remove the outer rotor (1). Clean all of the parts. Look for cracks in the metal or other damage. A worn oil pressure relief valve can allow oil to leak through the valve which lowers the oil pressure. 3. Install the outer rotor. Measure the clearance of the outer rotor to the body . The minimum oil pressure at a maximum engine speed of 2200 rpm and at normal operating temperature is 280 kPa (40 psi). A lower pressure is normal at low idle. A suitable pressure gauge can be used in order to test the pressure of the lubrication system. High Oil Pressure High oil pressure can be caused by the following conditions. The spring for the oil pressure relief valve is installed incorrectly.

The plunger for the oil pressure relief valve becomes jammed in the closed position. Illustration 102 g00938061 Typical example Excessive sludge exists in the oil which makes the viscosity of the oil too high. i03994211 Engine Oil Pump - Inspect 4. Measure the clearance of the inner rotor to the outer rotor (2). If any part of the oil pump is worn enough in order to affect the performance of the oil pump, the oil pump must be replaced.