Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Lubrication System 108 UENR4490-01 Refer to Specifications for more information regarding component wear limits. i02414692 Excessive Engine Oil Consumption - Inspect Engine Oil Leaks on the Outside of the Engine Check for leakage at the seals at each end of the crankshaft. Look for leakage at the gasket for the engine oil pan and all lubrication system connections. Look for any engine oil that may be leaking from the crankcase breather. This can be caused by combustion gas leakage around the pistons. A dirty crankcase breather will cause high pressure in the crankcase. A dirty crankcase breather will cause the gaskets and the seals to leak.

Illustration 103 g00938799 End play measurement of the rotor 5. Measure the end play of the outer rotor with a straight edge and a feeler gauge (3). 6. Clean the top face of the oil pump and the bottom face of the cover. Install the cover on the oil pump. Install the oil pump on the engine. Engine Oil Leaks into the Combustion Area of the Cylinders i04027269 Excessive Bearing Wear - Inspect Engine oil that is leaking into the combustion area of the cylinders can be the cause of blue smoke. There are several possible ways for engine oil to leak into the combustion area of the cylinders:

Failed valve stem seals When some components of the engine show bearing wear in a short time, the cause can be a restriction in an oil passage. Leaks between worn valve guides and valve stems An engine oil pressure indicator may show that there is enough oil pressure, but a component is worn due to a lack of lubrication. In such a case, look at the passage for the oil supply to the component. A restriction in an oil supply passage will not allow enough lubrication to reach a component. Early wear will result.

Worn components or damaged components (pistons, piston rings, or dirty return holes for the engine oil) Incorrect installation of the compression ring and/ or the intermediate ring Leaks past the seal rings in the turbocharger shaft Overfilling of the crankcase Wrong dipstick or guide tube Sustained operation at light loads