Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

114 UENR4490-01 Basic Engine Basic Engine i04319693 Position the Valve Mechanism Before Maintenance Procedures NOTICE Ensure that this procedure is carried out before the rocker shaft is removed. Table 11 Illustration 107 g02333215 Typical example One electronic unit injector is not shown for clarity. (1) The Crankshaft Turning Tool is used on the front pulley. (2) This Tool is used in the aperture for the electric starting motor. 2. Select an exhaust rocker arm (1). The exhaust rocker arm (1) can be on any cylinder. 3. Use Tooling (A) to rotate the crankshaft in the normal direction of rotation until the hydraulic lifter starts to open the exhaust valve.

Continue to rotate the crankshaft until the valve has opened to the maximum extent. This is the safe position. Note: Make temporary marks on the front pulley and the front housing once the engine is in the safe position. NOTICE Ensure that the crankshaft is located in the safe position before the rocker shaft assembly is installed. i03635080 Piston Ring Groove - Inspect Inspect the Piston and the Piston Rings Illustration 106 g01335181 Cylinder and valve location (A) Exhaust valve (B) Inlet valve 1. Check the piston for wear and other damage. 1. Remove the valve mechanism cover. Refer to Disassembly and Assembly, “Valve Mechanism Cover - Remove and Install” for the correct procedure. 2.

Check that the piston rings are free to move in the grooves and that the rings are not broken. Required Tools Tool Part Number Part Description Qty A(1) 21825576 Crankshaft Turning Tool 1 A(2) 27610291 Barring Device Housing 1 27610289 Gear 1