Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

120 UENR4490-01 Basic Engine i03578981 Gear Group - Inspect Illustration 116 g01199467 Typical example 1. Install Tooling (A). See illustration 116 . 2. Set the pointer of the dial indicator to 0 mm (0 inch). Illustration 117 g01907773 3. Check the alignment at intervals of 45 degrees around the flywheel housing. (1) Camshaft gear (2) Idler gear (3) Fuel injection pump gear 4. Calculate the difference between the lowest measurement and the highest measurement. This difference must not be greater than the limit that is given in Table 16 . Note:

If one or more of the gears need to be removed for repair, refer to Disassembly and Assembly, “Gear Group (Front) - Remove” in order to properly remove the gears. Refer to the Disassembly and Assembly, “Gear Group (Front) - Install” in order to properly install the gears. Note: Any necessary adjustment must be made on the flywheel housing. Table 16 1. Inspect the gears for wear or for damage. If the gears are worn or damaged, use new parts for replacement. 2. Measure the backlash between the camshaft gear (1) and the idler gear (2). Refer to Specifications, “Gear Group (Front)” for the backlash measurement. 3. Measure the backlash between the idler gear (2) and the crankshaft gear (4).

Refer to Specifications, “Gear Group (Front)” for the backlash measurement. 4. Measure the backlash between the fuel injection pump gear (3) and the idler gear (2). Refer to Specifications, “Gear Group (Front)” for the backlash measurement. Limits for Flywheel Housing Runout and Alignment (Total In- dicator Reading) Bore of the Housing Flange Maximum Limit (Total Indica- tor Reading) 410 mm (16.14 inch) 0.25 mm (0.010 inch) 448 mm (17.63 inch) 0.28 mm (0.011 inch)