Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Electrical System 126 UENR4490-01 Loose connections Corroded connections Faulty switch contacts Diagnosis Procedures The procedures for diagnosing the starting motor are intended to help the technician determine if a starting motor needs to be replaced or repaired. The procedures are not intended to cover all possible problems and conditions. The procedures serve only as a guide. NOTICE If equipped with electric start, do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Never turn the disconnect switch off while the engine is running. Serious damage to the electrical system can result.

Illustration 119 g00584419 Typical 24 V starting circuit (1) Test point (2) Test point (3) Test point (4) Test point (5) Test point (X) Hold-in coil (W) Pull-in coil