Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 31 Engine Operation Typical example (1) Exhaust inlet from back pressure valve (2) Selective Catalytic Reduction (SCR) system (3) Exhaust out (4) Ammonia sensor (if equipped) (5) Nitrogen Oxide (NOx) sensor (6) Diesel Exhaust Fluid (DEF) injector (7) Diesel Exhaust Fluid (DEF) supply line (8) Diesel Exhaust Fluid (DEF) pump and dosing control unit (9) Coolant supply from engine line (10) Coolant diverter valve (11) Diesel Exhaust Fluid (DEF) tank (12) Coolant supply connector (13) Suction connector (14) Backflow connector (15) Coolant return connector (16) DEF suction line (17) Electronic Control Module (ECM) Note: Illustration 24 is a schematic for illustrative purposes only.

Ensure that the diesel exhaust fluid pump is installed to the application in the correct orientation. Refer to Disassembly and Assembly, “Diesel Exhaust Fluid Pump - Remove and Install” for the correct procedure. DEF Pump The Diesel Exhaust Fluid (DEF) Dosing Control System consists of the following components. Pump Electronics Unit (PEU) DEF injector DEF header Coolant diverter valve DEF System Heated Lines Pump Electronics Unit (PEU) The Pump Electronics Tank Unit (PEU) consists of the following components. DEF pump Dosing Control Unit (DCU) The Dosing Control Unit (DCU) is mounted on the DEF pump assembly.

Illustration 25 g03708834 Typical example (1) DEF filter (2) Inlet (3) Outlet The pump supplies filtered DEF fluid to the DEF injector. The pump consists of inlet port (2) which is the suction side of the pump. The pump then pressurizes the fluid up to 550 kPa (80 psi) and supplies the fluid though outlet port (3). There is a fixed orifice within the DEF injector that governs the return flow from the DEF injector to the tank. This return flow will stabilize the temperature in the DEF injector when the DEF injector is exposed to the hot gases from the exhaust.