Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Engine Operation 34 UENR4490-01 DEF Injector Illustration 29 g03403971 Typical example Illustration 28 g03708843 Typical example (1) Sensing unit (2) Cable (black for engine out, gray for CEM out) (3) Sensor electronic control unit (4) Electrical connector (1) Electrical connector (2) DEF outlet connection (3) DEF inlet connection The DEF injector is mounted to the Clean Emissions Module (CEM). The DEF injector is a valve that injects DEF as a fine spray into the exhaust gases as an atomized mist before the Selective Catalytic Reduction (SCR). The spray pattern being conical for good mixing with the exhaust is critical.

The NOx sensor contains a sensing element, a harness, and an electronic control unit. The sensing element is composed of two chambers and a heater. The first chamber measures the amount of oxygen and the second chamber measure the amount of NOx and NH 3 . Using electrochemistry, a ceramic material attracts ions at approximately 800° C (1472° F) and an electrode on the chamber wall measures the electrical charge in voltage or current. The voltage or current signal is then received by the NOx sensors electronic control unit and interpreted into a NOx concentration. The heater is used to maintain the sensing element temperature, as sensing element is sensitive to moisture.

If the sensor detects moisture while at 800° C (1472° F), the moisture could quickly cool the element which would cause the element to crack. At engine start-up there is always some moisture within the exhaust pipes. The sensors will not operate until the exhaust temperature around the sensors is greater than 100° C (212° F) for approximately two and a half minutes. The tip of the injector, located in the exhaust flow, is cooled by the DEF that flows through an internal passage from the DEF heated lines. Nitrogen Oxide (NOx) Sensors There are two NOx sensors supplied with the engine. One NOx sensor is installed in the Clean Emissions Module (CEM).

The other NOx sensor is installed in the exhaust pipe of the application. The engine produces NOx as the engine operates. The engine out NOx sensor measures the amount and communicates that value to the Diesel Exhaust Fluid Control Unit (DCU). The tailpipe out NOx sensor monitors the NOx level out of the catalyst and communicates that value to the DCU. Engine out and tail pipe out NOx sensor values will determine the flow rate of the Diesel Exhaust Fluid (DEF) to meet the desired tail pipe out target. DEF System Heated Lines The DEF flows in the heated lines from the DEF tank to the pump in the Dosing Control Unit (DCU).

The DEF then travels through another heated line from the DCU to the DEF injector. The heated lines are heated by an electrical resistance.