Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 43 Engine Operation High Pressure Fuel System Illustration 34 g02450116 Typical example (1) Fuel injection pump (2) Fuel temperature sensor (3) Suction control valve for the fuel injection pump (4) Fuel pressure sensor (5) Electronic unit injector (6) Fuel manifold (rail) (7) Pressure relief valve (8) Fuel transfer pump The fuel injection pump (1) feeds fuel to the high- pressure fuel manifold (rail) (6). The fuel is at a pressure of 200 MPa (29000 psi). A pressure sensor (4) in the high-pressure fuel manifold (rail) (6) monitors the fuel pressure in the high-pressure fuel manifold (rail) (6).

The ECM controls a suction control valve (3) in the fuel injection pump (1) in order to maintain the actual pressure in the high-pressure fuel manifold (6) at the desired level. The high-pressure fuel is continuously available at each injector. The ECM determines the correct time for activation of the correct electronic unit injector (5) which allows fuel to be injected into the cylinder. The leakoff fuel from each injector passes into a drilling which runs along the inside of the cylinder head. A pipe is connected to the rear of the cylinder head in order to return the leakoff fuel to the fuel tank.

Electric transfer pump Fuel transfer pump Secondary fuel filter Fuel injection pump Fuel injectors Fuel manifold Pressure relief valve Fuel pressure sensor Fuel temperature sensor Components of the Fuel Injection System The following list contains examples of both service and repairs when you must prime the system: The fuel injection system has the following mechanical components: A fuel filter is changed. Primary filter/water separator A low-pressure fuel line is replaced.