UENR4490-01 47 Engine Operation (7) Coolant temperature sensor (8) Inlet manifold air temperature sensor (9) Secondary speed/timing sensor (10) Primary speed/timing sensor (11) Fuel injection pump (12) Suction control valve for the fuel injection pump (13) Fuel temperature sensor (14) Electronic unit injectors The ECM determines the quantity, timing, and pressure of the fuel in order to be injected into the fuel injector. Note: If a replacement electronic unit injector is installed, the correct injector code must be programmed into the electronic control module. Refer to Troubleshooting, “Injector Code - Calibrate” for more information. The code that is required is located at Position (X).
Record Code (X) before the electronic unit injector is installed. The ECM uses input from the sensors on the engine. These sensors include the speed/timing sensors and the pressure sensors. The ECM controls the timing and the flow of fuel by actuating the injector solenoid. The fuel injectors contain no serviceable parts apart from the O-ring seal and the combustion washer. The clamp and setscrew are serviced separately. The amount of fuel is proportional to the duration of the signal to the injector solenoid. The pressurized fuel from the fuel manifold is injected into the combustion chamber by the electronic unit injector.
The desired injection timing, injection quantity and injection pattern are controlled by the ECM depending on engine operating conditions. The ECM controls the fuel pressure by increasing or decreasing the flow of fuel from the fuel injection pump. Fuel Injectors The injection process is controlled using a two-way valve. The supply of electrical current to the solenoid controls the two-way valve. When the two-way valve is not energized the out orifice is closed and there is no fuel leak. In this condition the pressure in the control chamber and the pressure at the nozzle needle are the same. In this condition the spring pressure on the command piston keeps the needle closed.
When an injection of fuel is required, the electrical current from the ECM charges the solenoid, which in turn energizes the two-way valve and lifts the valve. When the valve lifts the valve uncovers the out orifice. The fuel starts to flow and reduces the pressure in the control chamber. When the pressure difference at the nozzle needle exceeds the combined pressure of the control chamber pressure and the spring pressure, the nozzle lifts to start the injection process. The fuel coming out of the nozzle is atomized and injected as a very fine spray.
When the injection needs to be stopped the electrical current to the solenoid is cut off and the pressure difference in the control chamber starts increasing. The increased pressure difference stops the injection process when the combined pressure exceeds the nozzle pressure. The electronic unit injectors can be instructed to inject fuel multiple times during the combustion process. A close pilot injection occurs before the main injection. The close pilot injection helps to reduce NOx and noise. The main injection period helps to increase the torque of the engine. The after injection period helps to reduce the amount of smoke that is produced.
Illustration 39 g02290433 Typical example (1) Electrical connections (2) Bolt (3) Clamp (4) Combustion washer (5) O-ring (6) Fuel inlet