Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Engine Operation 78 UENR4490-01 exists, the signal or the supply voltage can no longer reach the intended destination. Oxides of Nitrogen (NOx) – NOx is a component of the exhaust gases that are produced by the combustion process. NOx is reduced by the NRS system and is further reduced by the SCR component of the aftertreatment system. Parameter – A parameter is a value or a limit that is programmable. This helps determine specific characteristics or behaviors of the engine. Password – A password is a group of numeric characters or a group of alphanumeric characters that is designed to restrict access to parameters.

The electronic system requires correct passwords in order to change some parameters (Factory Passwords). Refer to Troubleshooting, “Factory Passwords” for more information. Illustration 68 g00284479 Pump, Electronics Unit (PEU) – The PEU is a module that controls the injection of Diesel Exhaust Fluid (DEF) into the exhaust gas stream. The module consists of a DEF pump, a filter, and a Dosing Control Unit (DCU). Programmable Software – The software is programmed into the ECM. The software contains all the instructions (software) for the ECM and the software contains the performance maps for a specific engine. The software may be reprogrammed through flash programming.

Rated Fuel Limit – This is a limit that is based on the power rating of the engine and on the engine rpm. The Rated Fuel Limit enables the engine power and torque outputs to conform to the power and torque curves of a specific engine model. These limits are in the flash file and these limits cannot be changed. Power Cycling – Power cycling refers to the action of cycling the keyswitch from any position to the OFF position, and to the START/RUN position. Reference Voltage – Reference voltage is a regulated voltage and a steady voltage that is supplied by the ECM to a sensor. The reference voltage is used by the sensor to generate a signal voltage.

Primary Speed/Timing Sensor – This sensor determines the position of the crankshaft during engine operation. If the primary speed/timing sensor fails during engine operation, the secondary speed/ timing sensor is used to provide the signal. Relay – A relay is an electromechanical switch. A flow of electricity in one circuit is used to control the flow of electricity in another circuit. A small current or voltage is applied to a relay in order to switch a much larger current or voltage. Pulse Width Modulation (PWM) – The PWM is a signal that consists of pulses that are of variable width. These pulses occur at fixed intervals. The ratio of TIME ON versus total TIME OFF can be varied.

This ratio is also referred to as a duty cycle. Secondary Speed/Timing Sensor – This sensor determines the position of the camshaft during engine operation. If the primary speed/timing sensor fails during engine operation, the secondary speed/ timing sensor is used to provide the signal. Selective Catalytic Reduction (SCR) – SCR is a process for reducing the oxides of nitrogen (NOx) in the exhaust gases. Ammonia is introduced into the exhaust and reacts with the exhaust gases in the SCR catalyst to convert the NOx into nitrogen and water vapor. Sensor – A sensor is used to detect a change in the pressure, in the temperature, or in mechanical movement.

When any of these changes are detected, a sensor converts the change into an electrical signal. Short Circuit – A short circuit is a condition that has an electrical circuit that is inadvertently connected to