Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 79 Engine Operation an undesirable point. An example of a short circuit is a wire which rubs against a vehicle frame and this rubbing eventually wears off the wire insulation. Electrical contact with the frame is made and a short circuit results. Total Tattletale – The total tattletale is the total number of changes to all the parameters that are stored in the ECM. Signal – The signal is a voltage or a waveform that is used in order to transmit information typically from a sensor to the ECM. Wait To Start Lamp – This is a lamp that is included in the cold starting aid circuit in order to indicate when the wait to start period has expired.

The glow plugs have not deactivated at this point in time. Suction Control Valve (SCV) – The SCV is a control device in the high-pressure fuel pump. The ECM controls the pressure in the fuel rail by using this valve to control the amount of fuel that enters the chambers in the pump. Wastegate – This is a device in a turbocharged engine that controls the maximum boost pressure that is provided to the inlet manifold. Supply Voltage – The supply voltage is a continuous voltage that is supplied to a component in order to provide the electrical power that is required for the component to operate.

The power may be generated by the ECM or the power may be battery voltage that is supplied by the engine wiring. Wastegate Regulator – The wastegate regulator controls the pressure in the intake manifold to a value that is determined by the ECM. The wastegate regulator provides the interface between the ECM and the wastegate. System Configuration Parameters – System configuration parameters are parameters that affect emissions and/or operating characteristics of the engine. Tattletale – Certain parameters that affect the operation of the engine are stored in the ECM. These parameters can be changed by use of the electronic service tool.

The tattletale logs the number of changes that have been made to the parameter. The tattletale is stored in the ECM. T Harness – This harness is a test harness that is designed to permit normal circuit operation and the measurement of the voltage simultaneously. Typically, the harness is inserted between the two ends of a connector. Throttle Position – The throttle position is the interpretation by the ECM of the signal from the throttle position sensor or the throttle switch. Throttle Position Sensor – The throttle position sensor is an electronic sensor that is usually connected to an accelerator pedal or a hand lever.

This sensor sends a signal to the ECM that is used to calculate desired engine speed. Throttle Switch – The throttle switch sends a signal to the ECM that is used to calculate desired engine speed. Top Center Position – The top center position refers to the crankshaft position when the engine piston position is at the highest point of travel. The engine must be turned in the normal direction of rotation in order to reach this point.