Fuel System 82 UENR4490-01 Illustration 70 g02352952 8. Connect Tooling (A) to the low-pressure fuel line and the secondary fuel filter base. Connect the open end of the tube to the inlet connection (1) of the secondary fuel filter base. Ensure that Tooling (A) is secured and clear of rotating parts. 12. Prime the fuel system. Refer to Operation and Maintenance Manual, “Fuel System - Prime” for the correct procedure. 9. Prime the fuel system. Refer to Operation and Maintenance Manual, “Fuel System - Prime” for the correct procedure. i04319691 Finding Top Center Position for No. 1 Piston 10. Start the engine.
Refer to Operation and Maintenance Manual, “Starting the Engine” for the correct procedure. Refer to steps 10.a to 10.d for the procedure for testing the air in fuel. Table 2 a. Run the engine a low idle speed. b. Run the engine for 2 minutes. There should be no air in the fuel flow through the sight tube. Small bubbles that are spaced more than 2.5 cm (1.0 inch) are acceptable. Do not manipulate the connections during the test for the air in fuel. c. The presence of large bubbles or a continuous stream of bubbles indicates a leak. (1) The Crankshaft Turning Tool is used on the front pulley. (2) This Tool is used in the aperture for the electric starting motor. d.
Investigate potential leaks and rectify any potential leaks in the low-pressure fuel system. Check for leaks in the connections of the inline fuel strainer. Check for leaks between the fuel tank and the inlet at the fuel transfer pump. If necessary, replace the low-pressure fuel lines. Note: Either Tooling (A) can be used. Use the Tooling that is most suitable. 1. Remove the front cover. Refer to Disassembly and Assembly, “Front Cover - Remove and Install”. 11. Remove Tooling (A). Reconnect the low-pressure lines.
Required Tools Tool Part Number Part Description Qty A(1) 21825576 Crankshaft Turning Tool 1 A(2) 27610291 Barring Device Housing 1 27610289 Gear 1 B 27610212 Timing Pin (Camshaft) 1 C T400014 Timing Pin (Crankshaft) 1