Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 83 Fuel System 3. Install Tooling (B) through the hole (X) in the camshaft gear (1) into the front housing. Use Tooling (B) in order to lock the camshaft in the correct position. i04319681 Fuel Injection Timing - Check Table 3 Illustration 71 g01907734 Typical example (1) The Crankshaft Turning Tool is used on the front pulley. (2) This Tool is used in the aperture for the electric starting motor. NOTICE Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.

Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, “General Hazard Information and High Pressure Fuel Lines” for safety information. Refer to Systems Operation, Testing and Adjust- ing, “Cleanliness of Fuel System Components” for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. This procedure must be done before any of the following: Removal of the fuel injection pump. Illustration 72 g01907735 Typical example The bolts that hold the fuel injection pump to the front housing are loosened. 2.

Use Tooling (A) in order to rotate the crankshaft until the Hole (X) in the camshaft gear (1) aligns with the hole in the front housing. Refer to illustration 71 . Remove the plug (2) from the cylinder block. Install Tooling (C) into the Hole (Y) in the cylinder block. Use Tooling (C) in order to lock the crankshaft in the correct position. 1. If necessary, install the fuel injection pump. Refer to Disassembly and Assembly, “Fuel Injection Pump - Install” for the correct procedure. Note: Do not use excessive force to install Tooling (C). Do not use Tooling (C) to hold the crankshaft during repairs.

Required Tools Tool Part Number Part Description Qty A(1) 21825576 Crankshaft Turning Tool 1 A(2) 27610291 Barring Device Housing 1 27610289 Gear 1 B T400014 Timing Pin (Crankshaft) 1 C T400015 Timing Pin (Fuel Injection Pump) 1