Fuel System 84 UENR4490-01 Note: The number one piston may be on the compression stroke or the exhaust stroke. 4. Install Tooling (B) into Hole (X) in the cylinder block. Use Tooling (B) in order to locate the crankshaft in the correct position. Note: Do not use excessive force to install Tooling (B). Do not use Tooling (B) to hold the crankshaft during repairs. 5. Remove Tooling (C) from the adapter plate. 6. Remove Tooling (B) from the cylinder block. i04026058 Fuel Quality - Test Note: Refer to Systems Operation, Testing and Adjusting, “Cleanliness of Fuel System Components” for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Illustration 73 g02337216 Typical example 2. Install Tooling (C) into hole in adapter plate at Position (Y). Use Tooling (A) to rotate the crankshaft until Tooling (C) locates into the slot in the gear for the fuel injection pump. Ensure that all adjustments and repairs are performed by authorized personnel that have had the correct training. Use the following procedure to test for problems regarding fuel quality: 1. Determine if water and/or contaminants are present in the fuel. Check the water separator. Drain the water separator, if necessary. A full fuel tank minimizes the potential for overnight condensation. Note:
A water separator can appear to be full of fuel when the water separator is full of water. 2. Determine if contaminants are present in the fuel. Remove a sample of fuel from the bottom of the fuel tank. Visually inspect the fuel sample for contaminants. The color of the fuel is not necessarily an indication of fuel quality. However, fuel that is black, brown, and/or like sludge can be an indication of the growth of bacteria or oil contamination. In cold temperatures, cloudy fuel indicates that the fuel may not be suitable for operating conditions. Illustration 74 g01958182 Typical example Refer to Operation and Maintenance Manual, “Fuel Recommendations” for more information. 3.
Remove plug (1) from the cylinder block. If necessary, use Tooling (A) in order to rotate the crankshaft until the number one piston is at the top center position.