Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 85 Fuel System 3. If fuel quality is still suspected as a possible cause to problems regarding engine performance, disconnect the fuel inlet line. Temporarily operate the engine from a separate source of fuel that is known to be good. This will determine if the problem is caused by fuel quality. If fuel quality is determined to be the problem, drain the fuel system and replace the fuel filters. Engine performance can be affected by the following characteristics: 1. Ensure that the fuel system is in working order. Check that the fuel supply valve (if equipped) is in the ON position. 2. Turn the keyswitch to the RUN position. 3.

The keyswitch will allow the electric priming pump to operate. Operate the electric priming pump for 2 minutes. 4. Turn the keyswitch to the OFF position. The fuel system should now be primed and the engine should be able to start. Cetane number of the fuel 5. Operate the engine starting motor and crank the engine. After the engine has started, operate the engine at low idle for a minimum of 5 minutes. Ensure that the fuel system is free from leaks. Viscosity of the fuel Lubricity of the fuel Air in the fuel Note: Operating the engine for this period will help ensure that the fuel system is free of air. DO NOT loosen the high-pressure fuel lines in order to purge air from the fuel system.

This procedure is not required. Other fuel characteristics Refer to Operation and Maintenance Manual, “Fuel Recommendations” for more information on the cetane number of the fuel. After the engine has stopped, you must wait for 10 minutes in order to allow the fuel pressure to be purged from the high-pressure fuel lines before any service or repair is performed on the engine fuel lines. The 10 minute wait will also allow static charge to dissipate from the low-pressure fuel system. If necessary, perform minor adjustments. Repair any leaks from the low-pressure fuel system and from the cooling, lubrication, or air systems. Replace any high- pressure fuel line that has leaked.

Refer to Disassembly and Assembly Manual, “Fuel Injection Lines - Install”. i05806374 Fuel System - Prime Note: Refer to Systems Operation, Testing, and Adjusting, “Cleanliness of Fuel System Components” for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. Ensure that all adjustments and repairs are performed by authorized personnel that have had the correct training. If you inspect the engine in operation, always use the proper inspection procedure in order to avoid a fluid penetration hazard. Refer to Operation and Maintenance Manual, “General hazard Information”.

NOTICE Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again. If the engine will not start, refer to Troubleshooting, “Engine Cranks but will not Start”. If air enters the fuel system, the air must be purged from the fuel system before the engine can be started. Air can enter the fuel system when the following events occur: The fuel tank is empty or the fuel tank has been partially drained. The low-pressure fuel lines are disconnected. A leak exists in the low-pressure fuel system. The fuel filter has been replaced. Use the following procedure in order to remove air from the fuel system: