Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Fuel System 86 UENR4490-01 i03578027 Gear Group (Front) - Time Illustration 75 g01907773 Typical example (1) Camshaft gear (2) Idler gear (3) Fuel Injection Pump gear 1. Install the camshaft gear (1) onto the camshaft. Refer to Disassembly and Assembly, “Camshaft Gear - Remove and Install” for the correct procedure. 2. Ensure that the crankshaft and the camshaft are locked in the correct position. Refer to Systems Operation, Testing and Adjusting, “Finding Top Center Position for No. 1 Piston” for the correct procedure. Ensure that the fuel injection pump is locked in the correct position. Refer to Disassembly and Assembly, “Fuel Injection Pump - Remove” for the correct procedure. 3.

Install the idler gear (2). Refer to Disassembly and Assembly, “Idler Gear - Remove and Install” for the correct procedure. 4. Install the fuel injection pump and gear assembly (3). Refer to Disassembly and Assembly, “Fuel Injection Pump - Install” for the correct procedure. 5. Make sure that the timing marks on the gears (1), (2) and (3) are in alignment. If the timing marks are not aligned, refer to Disassembly and Assembly, “Gear Group (Front) - Remove and Install”.