Air Inlet and Exhaust System 88 UENR4490-01 2. If there is sludge or debris in the canister, remove the canister. Refer to Disassembly and Assembly, “Crankcase Breather - Remove and Install”. Clean the inside of the canister. Check that the gas inlet, the outlet connections, and the connections for the oil drain are clear. a. Remove the breather hoses and visually check the insides for signs of blockage and check with low-pressure air. If necessary, clean the hoses. b. If necessary, replace the element for the crankcase breather. Refer to Operation and Maintenance Manual, “Engine Crankcase Breather Element - Replace”. c. Install the canister and hoses.
Refer to Disassembly and Assembly, “Crankcase Breather - Remove and Install”. 3. Check that the outlet for the crankcase breather is clean and free of obstructions. Ice can cause an obstruction in adverse weather conditions. If excessive crankcase pressure is experienced and the pressure relief valve for the crankcase breather has not activated, there could be a blockage in the valve mechanism cover. Illustration 77 g02161630 Typical example 1. Remove the valve mechanism cover. Refer to Disassembly and Assembly, “Valve Mechanism Cover - Remove and Install” for the correct procedure. (4) Breather tube (5) Breather assembly (6) Drain tube (7) One way valve (8) Outlet 2.
Inspect the inside of the valve cover for debris. The separator for the oil in the cover must be inspected. Ensure that all debris is removed from the cover. If the filter for the crankcase breather becomes blocked, the pressure relief valve will operate. The pressure relief valve will also operate if there is a blockage in the system. Note: Do not attempt to remove the separator from the cover. The separator can be cleaned if the separator is still attached to the cover. A general visual inspection should be made of the crankcase breather. To indicate that the pressure relief valve for the crankcase breather has been in operation, the following issues will be seen.
These issues are found behind the breather canister. i05934744 Turbocharger - Inspect (Series Turbochargers) Smearing of the oil Droplets of oil Wet patches of oil 1. Check the element for the engine crankcase breather. If necessary, replace the element for the crankcase breather. Refer to Operation and Maintenance Manual, “Engine Crankcase Breather Element - Replace”. Hot engine components can cause injury from burns. Before performing maintenance on the en- gine, allow the engine and the components to cool.