Komatsu — 12.11.1 METHOD OF ANGLING BLADE (ANGLEDOZER ONLY)

12. OPERATION 12.11 ADJUSTING POSTURE OF WORK EQUIPMENT 12.11 .I METHOD OF ANGLING BLADE (ANGLEDOZER ONLY) Angle the blade when it is needed to dump the soil on one side. I A WARNING When adjusting the amount of angling, it is danger- ous if the work equipment is moved by mistake. Set the work equipment in a safe condition, then stop the engine and lock the work equipment securely with the safety lever. Be careful when removing arm 0. After arm @ is removed the blade can move freely. 1. Raise the blade 400 - blocks under the frame down. 2. Remove pins 0 on the arm 0 from the frame. left and right sides, then remove 3.

Insert arm 0 into the desired position on the bracket on top of the frame (3 places on each side), and insert pin 0. 2-77