12. OPERATION 12.11.3 ADJUST ANGLE OF BLADE EDGE A WARNING It is dangerous if the work equipment moves by mistake when adjusting angle of the blade edge. Set the work 1 equipment in a stable condition, then stop the engine and apply the locks securely to the safety lever. Adjust the angle (0) of the blade edge to match the type of soil. l Angledozer Adjust the cutting angle by changing the distance (Q) be- tween the joints so that the length of the brace is the same on the left and right sides. INCREASE distance (Q) to INCREASE angle (0). DECREASE distance (Q) to DECREASE angle (13). The standard for the cutting angle (19) is 55”.
The standard for the distance (Q) between the joints is 1127 mm. l Power tiltdozer Turn the brace with bar handle 0 and adjust the distance (Q) between the joints to change the cutting angle (13) as fol- lows. INCREASE distance (Q) to INCREASE angle (13). DECREASE distance (Q) to DECREASE angle (0). The standard for the cutting angle (0) is 55”. The standard for the distance (Q) between the joints is 1150 mm. 2-79