24. SERVICE PROCEDURE 24.1.8 ADJUST IDLER CLEARANCE Since the idlers are forced to move forward and backward by an external force guide plates 0 will be worn out. Wear of these plates will cause the vibration of idlers from side to side or inclination of the idlers, and running off of track links from the idlers or unevenly worn idler and links may result. Therefore, adjust the idlers according to the following procedure. Adjustment 1. Move machine about 1 or 2 meters on a flat ground. 2. Measure the clearance A (4 locations: left, right, inside and outside) between the track frame and the guide plate. 3.
If the clearance A exceeds 4.0 mm, loosen bolt 0, and pull out the shim to adjust the clearance at one end to 0.5 - 1.0 mm. REMARK Thickness of one shim is 1 .O mm. 3-35